4 - 282
Chapter 4 Disassembly / Assembly and Adjustments
9) Attach the ferrite core.
10) Route the harness of the IIT ASSY
SUB through the hole of the frame.
11) Route the HARN ASSY ADF along
the hook of the HOLDER FFC.
Engage the two connectors (P/J1002
and 1003) on the PWBA ESS AIO,
secure the harness of the IIT ASSY
SUB using the clamp. Secure the
ground wire of the HARN ASSY
ADF to the printer with the one
screw (silver, 6mm).
To Next Page
Loading...
