Fuji Xerox DocuPrint CM305 df - Setting Initial Settings on the Operator Panel

2 - 25
Chapter 2 Troubleshooting
035
720
Fax Communication
Error
Error 035-720
Press Ok Button
<Not Receive Ability>
Remote device has no ability to receive.
FIP-1.42
728
Fax Communication
Error
Error 035-728
Press Ok Button
<G3 EOL Not Receive>
In G3 image data receive, cannot receive EOL for 13
sec(default).
FIP-1.42
729
Fax Communication
Error
Error 035-729
Press Ok Button
<Career Cut>
Career cut.
FIP-1.42
730
Fax Communication
Error
Error 035-730
Press Ok Button
<RS Request CS NOT ON>
In high-speed training, modem CS does not become ON
against RS request.
FIP-1.42
737
Fax Communication
Error
Error 035-737
Press Ok Button
<CTC/EOR Resend Over>
CTC/EOR resend over.
FIP-1.42
739
Fax Communication
Error
Error 035-739
Press Ok Button
<T5 Time Out>
T5 timeout.
FIP-1.42
740
Fax Communication
Error
Error 035-740
Press Ok Button
<ECM Send EOR-Q Send>
IN ECM send, send EOR-Q.
FIP-1.42
742
Fax Communication
Error
Error 035-742
Press Ok Button
<ECM Receive EOR-Q Receive>
IN ECM receive, receive EOR-Q.
FIP-1.42
779
Fax Communication
Error
Error 035-779
Press Ok Button
<FAX FWD document change error>
FAX forward document change error.
FIP-1.51
781
Target Fax Busy
Error 035-781
Press Ok Button
<Busy Job Failure>
Detect busy tone after dialing.
FIP-1.52
792
Fax Communication
Error
Error 035-792
Press Ok Button
<JM Not Detection>
JM undetected.
FIP-1.25
793
Fax Communication
Error
Error 035-793
Press Ok Button
<Digital Line Detection>
Connected to digital line and cannot connect. (Detect
when connecting to line)
FIP-1.53
041 340
MCU NVRAM Error
Error 041-340
Error Code:xxxxxxxx
Restart Printer
<IOT NVRAM Error>
The operation error of NVM (read/write check error etc.)
is detected.
FIP-1.54
Status
Code
Error Message
Status Contents
FIP to be
referred
LCD