Fujitsu PRIMERGY RX2540 M6

▶
Release the screw (see circle).
▶
Pull the HDD backplane upward until the two hooks disengage (see orange
circles).
▶
Take out the HDD backplane.
Installing the new 8x 2.5-inch HDD backplane
Figure 86: Installing the 8x 2.5-inch SAS HDD/SSD backplane
▶
Position the HDD backplane on the two hooks (see orange circles).
▶
Push the HDD backplane downward. Make sure that the HDD backplane fits
into the guide pins.
▶
Fasten the screw (see circle).
▶
If applicable, install the internal RAID riser module, see "Installing the
internal RAID riser module" on page
271
.
▶
If applicable, install the SAS expander board holder, see "Installing the SAS
expander board holder" on page 206.
Hard disk drive (HDD) / solid state disk (SSD)
RX2540 M6 Upgrade and Maintenance Manual 181