Operation Manual – VLAN
H3C S3100 Series Ethernet Switches Chapter 2 VLAN Configuration
2-2
Caution:
z VLAN 1 is the system default VLAN, which needs not to be created and cannot be
removed, either.
z The VLAN you created in the way described above is a static VLAN. On the switch,
there are dynamic VLANs which are registered through GVRP. For details, refer to
“GVRP” part of this manual.
z When you use the vlan command to create VLANs, if the destination VLAN is an
existing dynamic VLAN, it will be transformed into a static VLAN and the switch will
output the prompt information.
2.1.3 Basic VLAN Interface Configuration
I. Configuration prerequisites
Before configuring a VLAN interface, create the corresponding VLAN.
II. Configuration procedure
Follow these steps to perform basic VLAN interface configuration:
To do... Use the command... Remarks
Enter system view
system-view
—
Create a VLAN
interface and enter
VLAN interface view
interface
Vlan-interface
vlan-id
Required
By default, there is no VLAN
interface on a switch.
Specify the
description string for
the current VLAN
interface
description text
Optional
By default, the description string of a
VLAN interface is the name of this
VLAN interface. Vlan-interface1
Interface for example.
To Next Page
Loading...
Need help?
General