H3C S3100 8C SI User Manual

Operation Manual – AAA
H3C S3100 Series Ethernet Switches Chapter 2 AAA Configuration
2-18
2.2.6 Configuring the Type of RADIUS Servers to be Supported
Table 2-16 Configure the type of RADIUS servers to be supported
Operation Command Remarks
Enter system view
system-view
—
Create a RADIUS scheme
and enter its view
radius scheme
radius-scheme-name
Required
By default, a RADIUS
scheme named "system"
has already been created
in the system.
Configure the type of
RADIUS servers to be
supported
server-type { extended |
standard }
Optional
 Note:
z If you change the type of RADIUS server, the data stream destined to the original
RADIUS server will be restored to the default unit.
z When the third party RADIUS server is used, you can select standard or extended
as the server-type in a RADIUS scheme; when the CAMS server is used, you can
select extended as the server-type in a RADIUS scheme.
2.2.7 Configuring the Status of RADIUS Servers
For the primary and secondary servers (authentication/authorization servers, or
accounting servers) in a RADIUS scheme:
When the switch fails to communicate with the primary server due to some server
trouble, the switch will turn to the secondary server and exchange messages with the
secondary server.
After the primary server remains in the block state for a set time (set by the timer quiet
command), the switch will try to communicate with the primary server again when it
receives a RADIUS request. If it finds that the primary server has recovered, the switch
immediately restores the communication with the primary server instead of
communicating with the secondary server, and at the same time restores the status of
the primary server to active while keeping the status of the secondary server
unchanged.
When both the primary and secondary servers are in active or block state, the switch
sends messages only to the primary server.

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English