H3C S3100 8C SI User Manual

Operation Manual – Login
H3C S3100 Series Ethernet Switches Chapter 7 User Control
7-3
Operation Command Description
Quit to system view
quit
—
Enter user
interface view
user-interface [ type ]
first-number
[ last-number ]
—
Apply the ACL to
control Telnet
users by specified
source and
destination IP
addresses
acl acl-number
{ inbound | outbound }
Required
The inbound keyword specifies to
filter the users trying to Telnet to
the current switch.
The outbound keyword specifies
to filter users trying to Telnet to
other switches from the current
switch.
7.2.4 Controlling Telnet Users by Source MAC Addresses
Controlling Telnet users by source MAC addresses is achieved by applying Layer 2
ACLs, which are numbered from 4000 to 4999.
Table 7-4 Control Telnet users by source MAC addresses
Operation Command Description
Enter system view
system-view
—
Create or enter
Layer 2 ACL view
acl number acl-number
—
Define rules for the
ACL
rule [ rule-id ] { deny |
permit } [ rule-string ]
Required
You can define rules as
needed to filter by specific
source MAC addresses.
Quit to system view
quit
—
Enter user
interface view
user-interface [ type ]
first-number [ last-number ]
—
Apply the ACL to
control Telnet
users by specified
source MAC
addresses
acl acl-number inbound
Required
By default, no ACL is applied
for Telnet users.

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English