H3C S3100 8C SI User Manual

Operation Manual – PoE-PoE Profile
H3C S3100 Series Ethernet Switches Chapter 1 PoE Configuration
1-6
1.2.6 Configuring the PD Compatibility Detection Function
After the PD compatibility detection function is enabled, the switch can detect the PDs
that do not conform to the 802.3af standard and supply power to them.
After the PoE feature is enabled, perform the following configuration to enable the PD
compatibility detection function.
Table 1-7 Configure the PD compatibility detection function
Operation Command Description
Enter system view
system-view
—
Enable the PD
compatibility detection
function
poe legacy enable
Required
Disabled by default.
1.2.7 Configuring PoE Over-Temperature Protection on the Switch
If this function is enabled, the switch disables the PoE feature on all ports when its
internal temperature exceeds 65°C (149°F) for self-protection, and restores the PoE
feature settings on all its ports when the temperature drops below 60°C (140°F).
Table 1-8 Configure PoE over-temperature protection on the switch
Operation Command Description
Enter system view
system-view
—
Enable PoE
over-temperature
protection on the switch
poe
temperature-protection
enable
Optional
Enabled by default.
 Note:
z When the internal temperature of the switch decreases from X (X>65°C, or X>149°F)
to Y (60°C≤Y<65°C, or 140°F≤Y<149°F), the switch still keeps the PoE function
disabled on all the ports.
z When the internal temperature of the switch increases from X (X<60°C, or X<140°F)
to Y (60°C<Y≤65°C, or 140°F
<Y≤149°F), the switch still keeps the PoE function
enabled on all the ports.

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English