Operation Manual – CLI
H3C S3100 Series Ethernet Switches Chapter 1 CLI Configuration
1-15
Error message Description
Wrong parameter A parameter entered is wrong.
found at '^' position An error is found at the '^' position.
1.4.5 Command Edit
The CLI provides basic command edit functions and supports multi-line editing. The
maximum number of characters a command can contain is 254.
Table 1-11 lists the CLI
edit operations.
Table 1-11 Edit operations
Press… To…
A common key
Insert the corresponding character at the cursor
position and move the cursor one character to
the right if the command is shorter than 254
characters.
Backspace key
Delete the character on the left of the cursor and
move the cursor one character to the left.
Left arrow key or <Ctrl+B> Move the cursor one character to the left.
Right arrow key or <Ctrl+F> Move the cursor one character to the right.
Up arrow key or <Ctrl+P>
Down arrow key or <Ctrl+N>
Display history commands.
<Tab>
Use the partial online help. That is, when you
input an incomplete keyword and press <Tab>,
if the input parameter uniquely identifies a
complete keyword, the system substitutes the
complete keyword for the input parameter; if
more than one keywords match the input
parameter, you can display them one by one (in
complete form) by pressing <Tab> repeatedly; if
no keyword matches the input parameter, the
system displays your original input on a new line
without any change.
To Next Page
Loading...
Need help?
General