To Next Page

To Previous Page

Operation Manual – FTP-SFTP-TFTP

H3C S3100 Series Ethernet Switches Chapter 1 FTP and SFTP Configuration

1-13

[ftp] get switch.bin

# Execute the quit command to terminate the FTP connection and return to user view.

[ftp] quit

# After downloading the file, use the boot boot-loader command to specify the

downloaded file (switch.bin) to be the application for next startup, and then restart the

switch. Thus the switch application is upgraded.

<Sysname> boot boot-loader switch.bin

<Sysname> reboot

 Note:

For information about the boot boot-loader command and how to specify the startup

file for a switch, refer to the “System Maintenance and Debugging” module of this

manual.

1.3 SFTP Configuration

Table 1-10 SFTP configuration tasks

Item Configuration task Description

Enabling an SFTP server Required

Configuring connection idle time Optional

SFTP Configuration: A

Switch Operating as an

SFTP Server

Supported SFTP client software —

SFTP Configuration: A

Switch Operating as an

SFTP Client

Basic configurations on an SFTP

client

—

1.3.1 SFTP Configuration: A Switch Operating as an SFTP Server

I. Enabling an SFTP server

Before enabling an SFTP server, you need to enable the SSH server function and

specify the service type of the SSH user as SFTP or all. For details, see the SSH server

configuration part of SSH Operation Manual of this manual.

H3C S3100 8C SI User Manual

Questions and Answers: