H3C S3100 8C SI User Manual

Operation Manual – Information Center
H3C S3100 Series Ethernet Switches Chapter 1 Information Center
1-14
1.2.6 Setting to Output System Information to a Log Host
Table 1-12 Set to output system information to a log host
Operation Command Description
Enter system view
system-view
—
Enable the information
center
info-center enable
Optional
Enabled by default.
Enable system
information output to a
log host
info-center loghost
host-ip-addr [ channel
{ channel-number |
channel-name } | facility
local-number ]*
Required
By default, the switch does
not output information to the
log host.
After you configure the
switch to output information
to the log host, the switch
uses information channel 2
by default.
Configure the source
interface through which
log information is sent
to the log host
info-center loghost
source interface-type
interface-number
Optional
By default, no source
interface is configured, and
the system automatically
selects an interface as the
source interface.
Configure the output
rules of system
information
info-center source
{ modu-name | default }
channel
{ channel-number |
channel-name } [ { log |
trap | debug } { level
severity | state state } ]*
Optional
Refer to
Table 1-8 for the
default output rules of
system information.
Set the format of the
time stamp to be sent
to the log host
info-center timestamp
loghost { date |
no-year-date | none }
Optional
By default, the time stamp
format of the information
output to the log host is
date.
 Note:
Be sure to set the correct IP address when using the info-center loghost command. A
loopback IP address will cause an error message prompting that this address is invalid.

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English