H3C S3100 8C SI User Manual

Operation Manual – PoE-PoE Profile
H3C S3100 Series Ethernet Switches Chapter 2 PoE Profile Configuration
2-1
Chapter 2 PoE Profile Configuration
2.1 Introduction to PoE Profile
On a large-sized network or a network with mobile users, to help network
administrators to monitor the PoE features of the switch, S3100 series Ethernet
switches provide the PoE profile features. A PoE profile is a set of PoE configurations,
including multiple PoE features.
Features of PoE profile:
z Various PoE profiles can be created. PoE policy configurations applicable to
different user groups are stored in the corresponding PoE profiles. These PoE
profiles can be applied to the ports used by the corresponding user groups.
z When users connect a PD to a PoE-profile-enabled port, the PoE configurations in
the PoE profile will be enabled on the port.
2.2 PoE Profile Configuration
2.2.1 Configuring PoE Profile
Table 2-1 Configure PoE profile
Operation Command Description
Enter system view
system-view
—
Create a PoE profile and enter
PoE profile view
poe-profile
profilename
Required
If the PoE file is created,
you will enter PoE profile
view directly through the
command.
Enable the PoE
feature on a port
poe enable
Required
Disabled by default.
Configure PoE mode
for Ethernet ports
poe mode { signal
| spare }
Optional
signal by default.
Configure the PoE
priority for Ethernet
ports
poe priority
{ critical | high |
low }
Optional
low by default.
Configure
the
relevant
features in
PoE
profile
Configure the
maximum power for
Ethernet ports
poe max-power
max-power
Optional
15,400 mW by default.
Quit system view
quit
—

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English