H3C S3100 8C SI User Manual

Operation Manual – DHCP
H3C S3100 Series Ethernet Switches Chapter 2 DHCP Snooping Configuration
2-13
 Note:
z If you configure a remote ID sub-option in both system view and on a port, the
remote ID sub-option configured on the port applies when the port receives a packet,
and the global remote ID applies to other interfaces that have no remote ID
sub-option configured.
z If you have configured a remote ID with the vlan vlan-id argument specified, and the
other one without the argument in Ethernet port view, the former remote ID applies
to the DHCP messages from the specified VLAN, while the latter one applies to
DHCP messages from other VLANs.
z In a port aggregation group, you can use this command to configure the primary and
member ports respectively. When Option 82 is added, however, the remote ID is
subject to the one configured on the primary port.
z The remote ID configured on a port will not be synchronized in the case of port
aggregation.
VI. Configure the padding format for Option 82
Table 2-12 Configure the padding format for Option 82
Operation Command Description
Enter system view
system-view
—
Configure the padding
format
dhcp-snooping
information
packet-format
{ extended | standard }
Optional
By default, the padding
format is in extended
format.
2.3.2 Configuring IP Filtering
 Note:
Only the S3100-EI series among S3100 series switches support IP filtering.
Table 2-13 Configure IP filtering
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English