H3C S3100 8C SI User Manual

Operation Manual – ARP
H3C S3100 Series Ethernet Switches Chapter 1 ARP Configuration
1-12
Table 1-9 Display and debug ARP
Operation Command Remarks
Display specific ARP
mapping table entries
display arp [ static | dynamic |
ip-address ]
Display the ARP mapping
entries related to a specified
string in a specified way
display arp [ dynamic | static ] |
{ begin | include | exclude }
regular-expression
Display the number of the
ARP entries of a specified
type
display arp count [ [ dynamic |
static ] [ | { begin | include |
exclude } regular-expression ] |
ip-address ]
Display the statistics about
the untrusted ARP packets
dropped by the specified
port
display arp detection statistics
interface interface-type
interface-number
Display the setting of the
ARP aging timer
display arp timer aging
Available in any
view.
Clear specific ARP entries
reset arp [ dynamic | static |
interface interface-type
interface-number ]
Available in user
view.
1.5 ARP Configuration Example
1.5.1 ARP Basic Configuration Example
I. Network requirement
z Disable ARP entry check on the switch.
z Set the aging time for dynamic ARP entries to 10 minutes.
z Add a static ARP entry, with the IP address being 192.168.1.1, the MAC address
being 000f-e201-0000, and the outbound port being Ethernet1/0/10 of VLAN 1.
II. Configuration procedure
<Sysname> system-view
[Sysname] undo arp check enable
[Sysname] arp timer aging 10
[Sysname] arp static 192.168.1.1 000f-e201-0000 1 Ethernet1/0/10

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English