H3C S3100 8C SI User Manual

Operation Manual – GVRP
H3C S3100 Series Ethernet Switches Chapter 1 GVRP Configuration
1-7
Table 1-2 Relations between the timers
Timer Lower threshold Upper threshold
Hold 10 centiseconds
This upper threshold is
less than or equal to
one-half of the timeout
time of the Join timer. You
can change the threshold
by changing the timeout
time of the Join timer.
Join
This lower threshold is
greater than or equal to
twice the timeout time of
the Hold timer. You can
change the threshold by
changing the timeout time
of the Hold timer.
This upper threshold is
less than one-half of the
timeout time of the Leave
timer. You can change the
threshold by changing the
timeout time of the Leave
timer.
Leave
This lower threshold is
greater than twice the
timeout time of the Join
timer. You can change the
threshold by changing the
timeout time of the Join
timer.
This upper threshold is
less than the timeout time
of the LeaveAll timer. You
can change the threshold
by changing the timeout
time of the LeaveAll timer.
LeaveAll
This lower threshold is
greater than the timeout
time of the Leave timer.
You can change threshold
by changing the timeout
time of the Leave timer.
32,765 centiseconds
 Note:
The following are recommended GVRP timer settings:
z GARP hold timer: 100 centiseconds (1 second)
z GARP Join timer: 600 centiseconds (6 seconds)
z GARP Leave timer: 3000 centiseconds (30 seconds)
z GARP LeaveAll timer: 120000 centiseconds (2 minutes)
1.2.4 Configuring GVRP Port Registration Mode
Follow these steps to configure GVRP port registration mode:
To do ... Use the command ... Remarks
Enter system view
system-view
—

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English