Operation Manual – HWPing
H3C S3100 Series Ethernet Switches Chapter 1 HWPing Configuration
1-24
7 1018 1 0 2000-04-03 09:50:48.8
8 1020 1 0 2000-04-03 09:50:36.8
9 1020 1 0 2000-04-03 09:50:30.8
10 1028 1 0 2000-04-03 09:50:22.8
For detailed output description, see the corresponding command manual.
1.3.3 FTP Test
I. Network requirements
Both the HWPing client and the FTP server are H3C S3100 series Ethernet switches.
Perform a HWPing FTP test between the two switches to test the connectivity to the
specified FTP server and the time required to upload a file to the server after the
connection is established. Both the username and password used to log in to the FTP
server are “admin”. The file to be uploaded to the server is cmdtree.txt.
II. Network diagram
Figure 1-4 Network diagram for the FTP test
III. Configuration procedure
z Configure FTP Server (Switch B):
Configure FTP server on Switch B. For specific configuration of FTP server, refer to the
FTP-SFTP-TFTP part of the manual.
z Configure HWPing Client (Switch A):
# Enable the HWPing client.
<Sysname> system-view
[Sysname] hwping-agent enable
# Create a HWPing test group, setting the administrator name to "administrator" and
test tag to "FTP".
[Sysname] hwping administrator ftp
# Configure the test type as ftp.
[Sysname-hwping-administrator-ftp] test-type ftp
# Configure the IP address of the FTP server as 10.2.2.2.
[Sysname-hwping-administrator-ftp] destination-ip 10.2.2.2
# Configure the FTP login username.
To Next Page
Loading...
Need help?
General