H3C S3100 8C SI - Configuring Real-Time Monitoring of the Running Status of the System; Scheduling a Reboot on the Switch

Operation Manual – System Maintenance and Debugging
H3C S3100 Series Ethernet Switches Chapter 4 Device Management
4-2
Table 4-2 Reboot the Ethernet switch
Operation Command Description
Reboot the Ethernet switch reboot [ unit unit-id ] Available in user view
4.2.3 Scheduling a Reboot on the Switch
After you schedule a reboot on the switch, the switch will reboot at the specified time.
Table 4-3 Schedule a reboot on the switch
Operation Command Description
Schedule a reboot on the switch,
and set the reboot date and time
schedule reboot at hh:mm
[ mm/dd/yyyy | yyyy/mm/dd ]
Optional
Schedule a reboot on the switch,
and set the delay time for reboot
schedule reboot delay
{ hh:mm | mm }
Optional
Enter system view
system-view
—
Schedule a reboot on the switch,
and set the reboot period
schedule reboot regularity at
hh:mm period
Optional
 Note:
The switch timer can be set to precision of one minute, that is, the switch will reboot
within one minute after the specified reboot date and time.
4.2.4 Configuring Real-time Monitoring of the Running Status of the System
This function enables you to dynamically record the system running status, such as
CPU, thus facilitating analysis and solution of the problems of the device.
Table 4-4 Configure real-time monitoring of the running status of the system
Operation Command Description
Enter system view
system-view
—
Enable real-time
monitoring of the running
status of the system
system-monitor enable
Optional
Enabled by default.