Operation Manual – Port Basic Configuration
H3C S3100 Series Ethernet Switches Chapter 1 Port Basic Configuration
1-1
Chapter 1 Port Basic Configuration
 Note:
Two functions are added to release 2107: configuring loopback detection for a list of
ports in bulk, and enabling auto-shutdown of loopback ports. For detailed description of
the two functions, refer to
1.1.5 Configuring Loopback Detection for an Ethernet Port.
1.1 Ethernet Port Configuration
1.1.1 Initially Configuring a Port
Table 1-1 Initially configure a port
Operation Command Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Enable the Ethernet port
undo shutdown
Optional
By default, the port is
enabled.
Use the shutdown
command to disable the
port.
Set the description string
for the Ethernet port
description text
Optional
By default, the description
string of an Ethernet port
is null.
Set the duplex mode of
the Ethernet port
duplex { auto | full | half }
Optional
By default, the duplex
mode of the port is auto
(auto-negotiation).