Operation Manual – GVRP
H3C S3100 Series Ethernet Switches Chapter 1 GVRP Configuration
1-5
z Normal. A port in this mode can dynamically register/deregister VLANs and
propagate dynamic/static VLAN information.
z Fixed. A port in this mode cannot register/deregister VLANs dynamically. It only
propagates static VLAN information. Besides, the port permits only static VLANs,
that is, it propagates only static VLAN information to the other GARP members.
z Forbidden. A port in this mode cannot register/deregister VLANs dynamically. It
permits only the default VLAN (namely, VLAN 1), that is, the port propagates only
the information about VLAN 1 to the other GARP members.
1.1.3 Protocol Specifications
GVRP is defined in IEEE 802.1Q standard.
1.2 GVRP Configuration
1.2.1 GVRP Configuration Tasks
Complete the following tasks to configure GVRP:
Task Remarks
Enabling GVRP
Required
Configuring GVRP Timers
Optional
Configuring GVRP Port Registration
Mode
Optional
1.2.2 Enabling GVRP
I. Configuration Prerequisite
The port on which GVRP will be enabled must be set to a trunk port.
II. Configuration procedure
Follow these steps to enable GVRP:
To do ... Use the command ... Remarks
Enter system view
system-view
—
Enable GVRP globally
gvrp
Required
By default, GVRP is
disabled globally.
Enter Ethernet port view
interface interface-type
interface-number
—
To Next Page
Loading...
