Operation Manual – NTP
H3C S3100 Series Ethernet Switches Chapter 1 NTP Configuration
1-10
I. Configuring a switch to work in the NTP broadcast server mode
Table 1-5 Configure a switch to work in the NTP broadcast server mode
Operation Command Description
Enter system view
system-view
—
Enter VLAN interface view
interface Vlan-interface
vlan-id
—
Configure the switch to
work in the NTP
broadcast server mode
ntp-service
broadcast-server
[ authentication-keyid
key-id | version number ]*
Required
Not configured by default.
II. Configuring a switch to work in the NTP broadcast client mode
Table 1-6 Configure a switch to work in the NTP broadcast client mode
Operation Command Description
Enter system view
system-view
—
Enter VLAN interface view
interface Vlan-interface
vlan-id
—
Configure the switch to
work in the NTP
broadcast client mode
ntp-service
broadcast-client
Required
Not configured by default.
1.3.4 Configuring NTP Multicast Mode
For switches working in the multicast mode, you need to configure both the server and
clients. The multicast server periodically sends NTP multicast messages to multicast
clients. The switches working in the NTP multicast client mode will respond to the NTP
messages, so as to start the clock synchronization.
An H3C S3100 series Ethernet switch can work as a multicast server or a multicast
client.
z Refer to Table 1-7 for configuring a switch to work in the NTP multicast server
mode.
z Refer to Table 1-8 for configuring a switch to work in the NTP multicast client
mode.