H3C S3100 8C SI User Manual

Operation Manual – 802.1x-System Guard
H3C S3100 Series Ethernet Switches Chapter 1 802.1x Configuration
1-20
1.4.3 Enabling DHCP-triggered Authentication
After performing the following configuration, 802.1x allows running DHCP on access
users, and users are authenticated when they apply for dynamic IP addresses through
DHCP.
Table 1-5 Enable DHCP-triggered authentication
Operation Command Remarks
Enter system view
system-view
—
Enable DHCP-triggered
authentication
dot1x dhcp-launch
Required
By default,
DHCP-triggered
authentication is disabled.
1.4.4 Configuring Guest VLAN
Table 1-6 Configure Guest VLAN
Operation Command Remarks
Enter system view
system-view
—
Configure port
access method
dot1x port-method
portbased
Required
The default port access
method is
MAC-address-based. That is,
the macbased keyword is
used by default.
In
system
view
dot1x guest-vlan vlan-id
[ interface interface-list ]
interface interface-type
interface-number
dot1x guest-vlan vlan-id
Enable
the
Guest
VLAN
function
In port
view
quit
Required
By default, the Guest VLAN
function is disabled.

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English