H3C S3100 8C SI User Manual

Operation Manual – HWPing
H3C S3100 Series Ethernet Switches Chapter 1 HWPing Configuration
1-6
Table 1-4 HWPing server configuration
Operation Command Description
Enter system view
system-view
—
Enable the HWPing
server function
hwping-server enable
Required
Disabled by default.
Configure a UDP listening
service
hwping-server udpecho
ip-address port-num
Required for UDP and
jitter tests
By default, no UDP
listening service is
configured.
Configure a TCP listening
service
hwping-server
tcpconnect ip-address
port-num
Required for TCP tests
By default, no TCP
listening service is
configured.
1.2.2 HWPing Client Configuration
I. HWPing client configuration
After HWPing client is enabled, you can create multiple test groups for different tests,
without the need to enable HWPing client repeatedly for each test group.
Different types of HWPing tests are somewhat different in parameters and parameter
ranges. The following text describes the configuration on HWPing client for different
test types.
1) Configuring ICMP test on HWPing client
Table 1-5 Configure ICMP test on HWPing client
Operation Command Description
Enter system view
system-view
—
Enable the HWPing client
function
hwping-agent enable
Required
By default, the HWPing
client function is disabled.
Create a HWPing test
group and enter its view
hwping
administrator-name
operation-tag
Required
By default, no test group
is configured.
Configure the test type
test-type icmp
Optional
By default, the test type is
ICMP.
Configure the destination
IP address
destination-ip ip-address
Required
By default, no destination
address is configured.

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English