H3C S3100 8C SI User Manual

Operation Manual – AAA
H3C S3100 Series Ethernet Switches Chapter 2 AAA Configuration
2-17
Operation Command Remarks
Set a shared key for
RADIUS accounting
messages
key accounting string
Required
By default, no shared key
is created.
Caution:
The authentication/authorization shared key and the accounting shared key you set on
the switch must be respectively consistent with the shared key on the
authentication/authorization server and the shared key on the accounting server.
2.2.5 Configuring the Maximum Number of RADIUS Request
Transmission Attempts
The communication in RADIUS is unreliable because this protocol uses UDP packets
to carry its data. Therefore, it is necessary for the switch to retransmit a RADIUS
request if it gets no response from the RADIUS server after the response timeout timer
expires. If the switch gets no answer after it has tried the maximum number of times to
transmit the request, the switch considers that the request fails.
Table 2-15 Configure the maximum transmission attempts of a RADIUS request
Operation Command Remarks
Enter system view
system-view
—
Create a RADIUS scheme
and enter its view
radius scheme
radius-scheme-name
Required
By default, a RADIUS
scheme named "system" has
already been created in the
system.
Set the maximum number
of RADIUS request
transmission attempts
retry retry-times
Optional
By default, the system can try
three times to transmit a
RADIUS request.

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English