H3C S3100 8C SI - Configuring Static Member Port for a Multicast Group

Operation Manual – Multicast
H3C S3100 Series Ethernet Switches Chapter 2 IGMP Snooping Configuration
2-12
Operation Command Remarks
Enable IGMP Snooping
igmp-snooping enable
Required.
Enable IGMP Snooping
querier
igmp-snooping querier
Required
By default, IGMP
Snooping querier is
disabled.
Configure the interval
between general queries
igmp-snooping
query-interval seconds
Optional
By default, the interval
between general queries
is 60 seconds.
Configure the source IP
address of general
queries
igmp-snooping
general-query source-ip
{ current-interface |
ip-address }
Optional
By default, the source IP
address of general
queries is 0.0.0.0.
2.2.8 Configuring Static Member Port for a Multicast Group
If the host connected to a port is interested in the multicast data for a specific group, you
can configure that port as a static member port for that multicast group.
I. In Ethernet port view
Table 2-12 Configure a static multicast group member port in Ethernet port view
Operation Command Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Configure the current port
as a static member port
for a multicast group in a
VLAN
multicast static-group
group-address vlan
vlan-id
Required
By default, no port is
configured as a static
multicast group member
port.
II. In VLAN interface view
Table 2-13 Configure a static multicast group member port in VLAN interface view
Operation Command Remarks
Enter system view
system-view
—
Enter VLAN interface view
interface vlan-interface
interface-number
—