H3C S3100 8C SI User Manual

Operation Manual – 802.1x-System Guard
H3C S3100 Series Ethernet Switches Chapter 1 802.1x Configuration
1-18
 Note:
z As for the dot1x max-user command, if you execute it in system view without
specifying the interface-list argument, the command applies to all ports. You can
also use this command in port view. In this case, this command applies to the
current port only and the interface-list argument is not needed.
z As for the configuration of 802.1x timers, the default values are recommended.
1.4 Advanced 802.1x Configuration
Advanced 802.1x configurations, as listed below, are all optional.
z Configuration concerning CAMS, including multiple network adapters detecting,
proxy detecting, and so on.
z Client version checking configuration
z DHCP–triggered authentication
z Guest VLAN configuration
z 802.1x re-authentication configuration
z Configuration of the 802.1x re-authentication timer
You need to configure basic 802.1x functions before configuring the above 802.1x
features.
1.4.1 Configuring Proxy Checking
Table 1-3 Configure proxy checking
Operation Command Remarks
Enter system view
system-view
—
Enable proxy checking
function globally
dot1x
supp-proxy-check
{ logoff | trap }
Required
By default, the 802.1x
proxy checking function is
globally disabled.
In system
view
dot1x
supp-proxy-check
{ logoff | trap }
[ interface interface-list ]
interface interface-type
interface-number
dot1x
supp-proxy-check
{ logoff | trap }
Enable
proxy
checking
for a
port/specifi
ed ports
In port view
quit
Required
By default, the 802.1x
proxy checking is disabled
on a port.

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English