H3C S3100 8C SI User Manual

Operation Manual – Multicast
H3C S3100 Series Ethernet Switches Chapter 2 IGMP Snooping Configuration
2-13
Operation Command Remarks
Configure specified
port(s) as static member
port(s) of a multicast
group in the VLAN
multicast static-group
group-address interface
interface-list
Required
By default, no port is
configured as a static
multicast group member
port.
2.2.9 Configuring a Static Router Port
In a network where the topology is unlikely to change, you can configure a port on the
switch as a static router port, so that the switch has a static connection to a multicast
router and receives IGMP messages from that router.
I. In Ethernet port view
Table 2-14 Configure a static router port in Ethernet port view
Operation Command Remarks
Enter system view
system-view
—
Enter Ethernet port view
interface interface-type
interface-number
—
Configure the current port
as a static router port
multicast
static-router-port vlan
vlan-id
Required
By default, no static router
port is configured.
II. In VLAN view
Table 2-15 Configure a static router port in VLAN view
Operation Command Remarks
Enter system view
system-view
—
Enter VLAN view
vlan vlan-id —
Configure a specified port
as a static router port
multicast
static-router-port
interface-type
interface-number
Required
By default, no static router
port is configured.
2.2.10 Configuring a Port as a Simulated Group Member
Generally, hosts running IGMP respond to the IGMP query messages of the multicast
switch. If hosts fail to respond for some reason, the multicast switch may consider that

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English