H3C S3100 8C SI User Manual

Operation Manual – HWPing
H3C S3100 Series Ethernet Switches Chapter 1 HWPing Configuration
1-20
Operation Command Description
Enable the HWPing client
to send Trap messages
send-trap { all |
{ probefailure |
testcomplete |
testfailure }* }
Required
By default, Trap sending
is disabled.
Configure the number of
consecutive unsuccessful
HWPing tests before Trap
output
test-failtimes times
Optional
By default, Trap
messages are sent each
time a test fails.
Configure the number of
consecutive unsuccessful
HWPing probes before
Trap output
probe-failtimes times
Optional
By default, Trap
messages are sent each
time a probe fails.
1.2.3 Displaying HWPing Configuration
After the above-mentioned configuration, you can use the display commands to view
the results of the latest test and history information.
Table 1-15 Display HWPing test results
Operation Command Description
Display test history
display hwping history
[ administrator-name operation-tag ]
Display the results of
the latest test
display hwping results
[ administrator-name operation-tag ]
Available in any
view.
1.3 HWPing Configuration Example
1.3.1 ICMP Test
I. Network requirements
An H3C S3100 series Ethernet switch serves as the HWPing client. A HWPing ICMP
test between the switch and another switch uses ICMP to test the round trip time (RTT)
for packets generated by the HWPing client to travel to and back from the destination
switch.

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English