H3C S3100 8C SI User Manual

Operation Manual – QoS-QoS Profile
H3C S3100 Series Ethernet Switches Chapter 2 QoS Profile Configuration
2-2
The switch directly applies the QoS profile to the port the user is connected to.
 Note:
A user-based QoS profile application fails if the traffic classification rule defined in the
QoS profile contains source address information (including source MAC address
information, source IP address information, and VLAN information).
II. Manual application mode
You can use the apply command to manually apply a QoS profile to a port.
2.2 QoS Profile Configuration
Table 2-1 QoS profile configuration tasks
Operation Description Related section
Configure a QoS Profile Required
Section
Configuring a QoS
Profile
Configure to apply a QoS
Profile dynamically
Optional Section
Applying a QoS Profile
Apply a QoS Profile manually Optional Section Applying a QoS Profile
2.2.1 Configuring a QoS Profile
I. Configuration prerequisites
z The ACL rules used for traffic classification are defined. Refer to the ACL module
of this manual for information about defining ACL rules.
z The type and number of actions in the QoS profile are specified.
II. Configuration procedure
Table 2-2 Configure a QoS profile
Operation Command Description
Enter system view
system-view
—
Create a QoS profile
and enter QoS profile
view
qos-profile profile-name
Required
If the specified QoS
profile already exists, you
enter the QoS profile view
directly.

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English