H3C S3100 8C SI - Configuring Traffic Redirecting

Operation Manual – QoS-QoS Profile
H3C S3100 Series Ethernet Switches Chapter 1 QoS Configuration
1-27
I. Configuration prerequisites
z The port on which port rate limiting configuration is to be performed is determined.
z The target rate and the direction of rate limiting (inbound or outbound) are
determined.
II. Configuration procedure
Table 1-23 Configure port rate limiting
Operation Command Description
Enter system view
system-view
—
Enter Ethernet
port view
interface interface-type
interface-number
—
Configure port
rate limiting
line-rate { inbound | outbound }
target-rate
Required
By default, port rate
limiting is disabled.
III. Configuration example
z Configure port rate limiting for inbound packets on Ethernet 1/0/1.
z The rate limit is 1,024 Kbps
Configuration procedure:
<Sysname> system-view
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] line-rate inbound 1024
1.4.7 Configuring Traffic Redirecting
 Note:
Only H3C S3100-EI series switches support this configuration.
Refer to section
Traffic Redirecting for information about traffic redirecting.
I. Configuration prerequisites
z The ACL rules used for traffic classification are defined. Refer to the ACL module
of this manual for information about defining ACL rules.
z The traffic redirecting destination is determined.