Operation Manual – SNMP-RMON
H3C S3100 Series Ethernet Switches Chapter 1 SNMP Configuration
1-3
Table 1-1 Common MIBs
MIB attribute MIB content Related RFC
MIB II based on TCP/IP network device RFC 1213
RFC 1493
BRIDGE MIB
RFC 2675
RIP MIB RFC 1724
RMON MIB RFC 2819
Ethernet MIB RFC 2665
Public MIB
IF MIB RFC 1573
Private MIB
DHCP MIB
QACL MIB
MSTP MIB
VLAN MIB
IPV6 ADDRESS MIB
MIRRORGROUP MIB
QINQ MIB
802.x MIB
HGMP MIB
NTP MIB
Device management
Interface management
—
1.2 Configuring Basic SNMP Functions
SNMPv3 configuration is quite different from that of SNMPv1 and SNMPv2c. Therefore,
the configuration of basic SNMP functions is described by SNMP versions, as listed in
Table 1-2 and Table 1-3.
Table 1-2 Configure basic SNMP functions (SNMPv1 and SNMPv2c)
Operation Command Description
Enter system view
system-view
—
Enable SNMP agent
snmp-agent
Optional
Disabled by default.
You can enable SNMP
agent by executing
this command or any
of the commands
used to configure
SNMP agent.
To Next Page
Loading...
Need help?
General