H3C S3100 8C SI - Configuring a Description for an Aggregation Group

Operation Manual – Link Aggregation
H3C S3100 Series Ethernet Switches Chapter 1 Link Aggregation Configuration
1-10
Table 1-3 Configure a dynamic LACP aggregation group
Operation Command Remarks
Enter system view
system-view
—
Configure the system
priority
lacp system-priority
system-priority
Optional
By default, the system
priority is 32,768.
Enter Ethernet port view
interface interface-type
interface-number
—
Enable LACP on the port
lacp enable
Required
By default, LACP is
disabled on a port.
Configure the port priority
lacp port-priority
port-priority
Optional
By default, the port priority
is 32,768.
 Note:
Changing the system priority may affect the priority relationship between the
aggregation peers, and thus affect the selected/unselected status of member ports in
the dynamic aggregation group.
1.4.4 Configuring a Description for an Aggregation Group
Perform the following tasks to configure a description for an aggregation group.
Table 1-4 Configure a description for an aggregation group
Operation Command Remarks
Enter system view
system-view
—
Configure a description
for an aggregation group
link-aggregation group
agg-id description
agg-name
Optional
By default, no description
is configured for an
aggregation group.