H3C S3100 8C SI User Manual

Operation Manual – QoS-QoS Profile
H3C S3100 Series Ethernet Switches Chapter 2 QoS Profile Configuration
2-3
Operation Command Description
Configure traffic
policing
traffic-limit inbound acl-rule
target-rate [ burst-bucket
burst-bucket-size ] [ conform
con-action ] [ exceed
exceed-action ]
[ meter-statistic ]
Optional
Configure packet
filtering
packet-filter inbound
acl-rule
Optional
Refer to the ACL module
of this manual for
information about packet
filtering.
Configure priority
marking
traffic-priority inbound
acl-rule { dscp dscp-value |
cos cos-value |
local-precedence
pre-value }*
Optional
2.2.2 Applying a QoS Profile
You can configure to apply a QoS profile dynamically or simply apply a QoS profile
manually.
I. Configuration prerequisites
z To configure to apply a QoS profile dynamically, make sure 802.1x is enabled both
globally and on the port, and the authentication mode is determined. For
information about 802.1x, refer to the 802.1x and System Guard module of this
manual.
z To apply a QoS profile manually, make sure the port to which the QoS profile is to
be applied is determined.
z The QoS profile to be applied is determined.
II. Configuration procedure
Table 2-3 Configure to apply a QoS profile dynamically
Operation Command Description
Enter system view
system-view
—
Enter Ethernet port view
interface
interface-type
interface-number
—

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English