Operation Manual – HWPing
H3C S3100 Series Ethernet Switches Chapter 1 HWPing Configuration
1-5
Test parameter Description
Trap
z A HWPing test will generate a Trap message
no matter whether the test successes or not.
You can use the Trap switch to enable or
disable the output of trap messages.
z You can set the number of consecutive failed
HWPing tests before Trap output. You can
also set the number of consecutive failed
HWPing probes before Trap output.
1.2 HWPing Configuration
The TCP/UDP/jitter tests need the cooperation of HWPing client and HWPing Server,
Other types of tests need to configure HWPing client and corresponding different
servers.
1.2.1 Configuration on a HWPing Server
You can enable both the HWPing client and HWPing server functions on an H3C S3100
Ethernet switch, that is, the switch can serve as a HWPing client and server
simultaneously.
I. HWPing server configuration tasks
Table 1-3 HWPing server configuration tasks
Item Description Related section
Enable the HWPing
server function
The HWPing server function is needed
only for jitter, TCP, and UDP tests.
1.2.1 II.
Configure a listening
service on the HWPing
server
You can configure multiple TCP/UDP
listening services on one HWPing
server, with each listening service
corresponding to a specific destination
IP address and port number.
1.2.1 II.
II. HWPing server configuration
Table 1-4 describes the configuration on HWPing server, which is the same for HWPing
test types that need to configure HWPing server.
To Next Page
Loading...
Need help?
General