H3C S3100 8C SI - Setting to Output System Information to the SNMP NMS

Operation Manual – Information Center
H3C S3100 Series Ethernet Switches Chapter 1 Information Center
1-16
Operation Command Description
Configure the output rules
of system information
info-center source
{ modu-name | default }
channel
{ channel-number |
channel-name } [ { log |
trap | debug } { level
severity | state state } ]*
Optional
Refer to
Table 1-8 for the
default output rules of
system information.
Set the format of time
stamp in the output
information
info-center timestamp
{ log | trap | debugging }
{ boot | date | none }
Optional
By default, the time stamp
format of the output log
information is date.
1.2.9 Setting to Output System Information to the SNMP NMS
Table 1-15 Set to output system information to the SNMP NMS
Operation Command Description
Enter system view
system-view
—
Enable the information
center
info-center enable
Optional
Enabled by default.
Enable information output
to the SNMP NMS
info-center snmp
channel
{ channel-number |
channel-name }
Optional
By default, the switch
outputs trap information to
SNMP through channel 5.
Configure the output rules
of system information
info-center source
{ modu-name | default }
channel
{ channel-number |
channel-name } [ { log |
trap | debug } { level
severity | state state } ]*
Optional
Refer to
Table 1-8 for the
default output rules of
system information.
Set the format of time
stamp in the output
information
info-center timestamp
{ log | trap | debugging }
{ boot | date | none }
Optional
By default, the time stamp
format of the information
output to the SNMP NMS
is date.
 Note:
To send information to a remote SNMP NMS properly, related configurations are
required on both the switch and the SNMP NMS.