Operation Manual – System Maintenance and Debugging
H3C S3100 Series Ethernet Switches
Chapter 2 Basic System Configuration
and Debugging
2-4
2.3.2 Displaying Debugging Status
Table 2-4 Display the current debugging status in the system
Operation Command Description
Display all
enabled
debugging on the
switch
display debugging [ unit unit-id ]
[ interface interface-type
interface-number ]
[ module-name ]
You can execute the
display command in any
view.
2.3.3 Displaying Operating Information about Modules in System
When an Ethernet switch is in trouble, you may need to view a lot of operating
information to locate the problem. Each functional module has its corresponding
operating information display command(s). You can use the command here to display
the current operating information about the modules in the system for troubleshooting
your system.
Table 2-5 Display the current operation information about the modules in the system.
Operation Command Description
Display the current
operation
information about
the modules in the
system.
display
diagnostic-inform
ation
You can use this command in any
view.
You should execute this command
twice to find the difference between
the two executing results, thus helping
locate the problem.
To Next Page
Loading...
Need help?
General