H3C S3100 8C SI User Manual

Operation Manual – GVRP
H3C S3100 Series Ethernet Switches Chapter 1 GVRP Configuration
1-6
To do ... Use the command ... Remarks
Enable GVRP on the port
gvrp
Required
By default, GVRP is
disabled on the port.
 Notes
z After you enable GVRP on a trunk port, you cannot change the port to a different
type.
z Use the port trunk permit all command to permit the traffic of all dynamically
registered VLANs to pass through a trunk port with GVRP enabled.
1.2.3 Configuring GVRP Timers
Follow these steps to configure GVRP timers:
To do ... Use the command ... Remarks
Enter system view
system-view
—
Configure the LeaveAll
timer
garp timer leaveall
timer-value
Optional
By default, the LeaveAll
timer is set to 1,000
centiseconds.
Enter Ethernet port view
interface interface-type
interface-number
—
Configure the Hold, Join,
and Leave timers
garp timer { hold | join |
leave } timer-value
Optional
By default, the Hold, Join,
and Leave timers are set
to 10, 20, and 60
centiseconds
respectively.
Note that:
z The setting of each timer must be a multiple of 5 (in centiseconds).
z The timeout ranges of the timers vary depending on the timeout values you set for
other timers. If you want to set the timeout time of a timer to a value out of the
current range, you can set the timeout time of the associated timer to another
value to change the timeout range of this timer.
The following table describes the relations between the timers:

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English