H3C S3100 8C SI - Configuring Monitor Link; Configuration Tasks; Creating a Monitor Link Group

Operation Manual – Smart Link-Monitor Link
H3C S3100 Series Ethernet Switches Chapter 2 Monitor Link Configuration
2-3
 Note:
z Currently, member ports of a Monitor Link group cannot be dynamic link
aggregation groups.
z If the uplink or downlink port in the Monitor Link group is a link aggregation group,
you cannot directly delete this aggregation group or change this aggregation group
into a dynamic aggregation group. To delete this aggregation group, you must first
unbind this aggregation group from the Monitor Link.
2.2 Configuring Monitor Link
 Note:
Before configuring a Monitor Link group, you must create a Monitor Link group and
configure member ports for it. A Monitor Link group consists of an uplink port and one or
multiple downlink ports. The uplink port can be a manually-configured or static LACP
link aggregation group, an Ethernet port, or a Smart Link group. The downlink ports can
be manually-configured link aggregation groups or static LACP link aggregation groups,
or Ethernet ports.
2.2.1 Configuration Tasks
Table 2-1 Monitor Link configuration tasks
Task Remarks
Creating a Monitor Link Group Required
Configuring the Uplink Port Required
Configuring a Downlink Port Required
2.2.2 Creating a Monitor Link Group
Table 2-2 Create a Monitor Link group
Operation Command Remarks
Enter system view
system-view
—
Create a Monitor Link group
monitor-link group group-id
Required