Operation Manual – Login
H3C S3100 Series Ethernet Switches Chapter 3 Logging in through Telnet
3-1
Chapter 3 Logging in through Telnet
3.1 Introduction
S3100 series Ethernet switches support Telnet. You can manage and maintain a switch
remotely by Telnetting to the switch.
To log into a switch through Telnet, the corresponding configuration is required on both
the switch and the Telnet terminal.
You can also log into a switch through SSH. SSH is a secure shell added to Telnet.
Refer to the SSH Operation for related information.
Table 3-1 Requirements for Telnetting to a switch
Item Requirement
The IP address is configured for the VLAN of the switch, and the
route between the switch and the Telnet terminal is reachable.
(Refer to the IP Address Configuration – IP Performance
Configuration and Routing Protocol parts for more.)
Switch
The authentication mode and other settings are configured. Refer
to
Table 3-2 and Table 3-3.
Telnet is running.
Telnet terminal
The IP address of the VLAN of the switch is available.
 Note:
Telnetting to a switch using IPv6 protocols is similar to Telnetting to a switch using IPv4
protocols. Refer to the IPv6 Management part for related information.
3.1.1 Common Configuration
Table 3-2 lists the common Telnet configuration.
To Next Page
Loading...
Need help?
General