Operation Manual – IPv6 Management
H3C S3100 Series Ethernet Switches Chapter 2 IPv6 Application Configuration
2-3
I. Configuration preparation
Enable TFTP on the TFTP server and specify the path to download or upload files. For
specific operations, refer to TFTP server configuration specifications.
II. IPv6 TFTP configuration
You can use the commands listed in Table 2-3 to download files from a TFTP server or
upload files to a TFTP server.
Table 2-3 Download/upload files to TFTP servers
To do… Use the command… Remarks
Download/ Upload files
from TFTP server
tftp ipv6 remote-system
[ -i interface-type
interface-number ] { get |
put } source-filename
[ destination-filename ]
Required
Available in user view
Caution:
When you use the tftp ipv6 command to connect to the TFTP server, you must specify
the “–i” keyword if the destination address is a link-local address.
2.2.4 IPv6 Telnet
Telnet protocol belongs to application layer protocols of the TCP/IP protocol suite, and
is used to provide remote login and virtual terminals. The device can be used either as
a Telnet client or a Telnet server.
As the following figure shows, the Host is running Telnet client application of IPv6 to set
up an IPv6 Telnet connection with Device A, which serves as the Telnet server. If
Device A again connects to Device B through Telnet, the Device A is the Telnet client
and Device B is the Telnet server.
Figure 2-2 Provide Telnet services
To Next Page
Loading...
Need help?
General