Operation Manual – Information Center
H3C S3100 Series Ethernet Switches Chapter 1 Information Center
1-8
1.2 Information Center Configuration
1.2.1 Introduction to the Information Center Configuration Tasks
Table 1-4 Information center configuration tasks
Task Remarks
Configuring Synchronous Information Output Optional
Configuring to Display the Time Stamp with the UTC Time Zone Optional
Setting to Output System Information to the Console Optional
Setting to Output System Information to a Monitor Terminal Optional
Setting to Output System Information to a Log Host Optional
Setting to Output System Information to the Trap Buffer Optional
Setting to Output System Information to the Log Buffer Optional
Setting to Output System Information to the SNMP NMS Optional
1.2.2 Configuring Synchronous Information Output
Synchronous information output refers to the feature that if the system information such
as log, trap, or debugging information is output when the user is inputting commands,
the command line prompt (in command editing mode a prompt, or a [Y/N] string in
interaction mode) and the input information are echoed after the output.
This feature is used in the case that your input is interrupted by a large amount of
system output. With this feature enabled, the system echoes your previous input and
you can continue your operations from where you were stopped.
Table 1-5 Configure synchronous information output
Operation Command Description
Enter system view
system-view
—
Enable synchronous
information output
info-center
synchronous
Required
Disabled by default
To Next Page
Loading...
Need help?
General