Operation Manual – IPv6 Management
H3C S3100 Series Ethernet Switches Chapter 2 IPv6 Application Configuration
2-4
I. Configuration prerequisites
Enable Telnet on the Telnet server and configure the authentication method. For details,
refer to Login.
Table 2-4 Set up IPv6 Telnet connections
To do… Use the command… Remarks
Perform the telnet
command on the Telnet
client to log in to other
devices
telnet ipv6 remote-system [ -i
interface-type interface-number ]
[ port-number ]
Required
Available in user
view
Caution:
When you use the telnet ipv6 command to connect to the Telnet server, you must
specify the “–i” keyword if the destination address is a link-local address.
II. Display and maintain IPv6 Telnet
Table 2-5 Display and maintain IPv6 Telnet
To do… Use the command… Remarks
Display the use
information of the users
who have logged in
display users [ all ]
Available in any view
2.3 IPv6 Application Configuration Example
2.3.1 IPv6 Applications
I. Network requirements
In Figure 2-3, SWA, SWB, and SWC are three switches, among which SWA is an H3C
S3100 Ethernet switch, SWB and SWC are two switches supporting IPv6 forwarding. In
a LAN, there is a Telnet server and a TFTP server for providing Telnet service and
TFTP service to the switch respectively. It is required that you telnet to the telnet server
from SWA and download files from the TFTP server.
To Next Page
Loading...
Need help?
General