Operation Manual – IPv6 Management
H3C S3100 Series Ethernet Switches Chapter 2 IPv6 Application Configuration
2-5
II. Network diagram
SWA
SWB
SWC
3003::2/64
3003::1/64
3002::2/64
3002::1/64
3001::2/64
3001::4/64
3001::3/64
Telnet_Server TFTP_Server
Figure 2-3 Network diagram for IPv6 applications
III. Configuration procedure
Note:
You need configure IPv6 address at the switch’s and server’s interfaces and ensure
that the route between the switch and the server is accessible before the following
configuration.
# Ping SWB’s IPv6 address from SWA.
<SWA> ping ipv6 3003::1
PING 3003::1 : 64 data bytes, press CTRL_C to break
Reply from 3003::1
bytes=56 Sequence=1 hop limit=64 time = 110 ms
Reply from 3003::1
bytes=56 Sequence=2 hop limit=64 time = 31 ms
Reply from 3003::1
bytes=56 Sequence=3 hop limit=64 time = 31 ms
Reply from 3003::1
bytes=56 Sequence=4 hop limit=64 time = 31 ms
Reply from 3003::1
bytes=56 Sequence=5 hop limit=64 time = 31 ms
--- 3003::1 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
To Next Page
Loading...
