H3C S3100 8C SI User Manual

Operation Manual – Information Center
H3C S3100 Series Ethernet Switches Chapter 1 Information Center
1-12
 Note:
Make sure that the debugging/log/trap information terminal display function is enabled
(use the terminal monitor command) before you enable the corresponding terminal
display function by using the terminal debugging, terminal logging, or terminal
trapping command.
1.2.5 Setting to Output System Information to a Monitor Terminal
System information can also be output to a monitor terminal, which is a user terminal
that has login connections through the AUX, VTY, or TTY user interface.
I. Setting to output system information to a monitor terminal
Table 1-10 Set to output system information to a monitor terminal
Operation Command Description
Enter system view
system-view
—
Enable the information
center
info-center enable
Optional
Enabled by default.
Enable system
information output to
Telnet terminal or
dumb terminal
info-center monitor
channel
{ channel-number |
channel-name }
Optional
By default, a switch outputs
log/debugging/trap
information to a user
terminal through information
channel 1.
Configure the output
rules of system
information
info-center source
{ modu-name | default }
channel
{ channel-number |
channel-name } [ { log |
trap | debug } { level
severity | state state } ]*
Optional
Refer to
Table 1-8 for the
default output rules of
system information.
Set the format of time
stamp in the output
information
info-center timestamp
{ log | trap | debugging }
{ boot | date | none }
Optional
By default, the time stamp
format of the log and trap
output information is date,
and that of the debugging
output information is boot.

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English