H3C S3100 8C SI - Configuring the Enhanced Cluster Features

Operation Manual – Stack-Cluster
H3C S3100 Series Ethernet Switches Chapter 2 Cluste
r
2-18
Operation Command Description
Enter system view
system-view
—
Enter cluster view
cluster
—
Configuring MAC address
of Management device
administrator-address
mac-address name name
Optional
Add a candidate device to
the cluster
add-member
[ member-number ]
mac-address H-H-H
[ password password ]
Optional
Remove a member device
from the cluster
delete-member
member-number
Optional
Reboot a specified
member device
reboot member
{ member-number |
mac-address H-H-H }
[ eraseflash ]
Optional
Return to system view
quit
—
Return to user view
quit
—
Switch between
management device and
member device
cluster switch-to
{ member-number |
mac-address H-H-H |
administrator }
Optional
You can use this
command switch to the
view of a member device
and switch back.
Locate device through
MAC address and IP
address
tracemac { by-mac
mac-address vlan vlan-id
| by-ip ip-address }
[ nondp ]
Optional
These commands can be
executed in any view.
2.2.4 Configuring the Enhanced Cluster Features
I. Enhanced cluster feature overview
1) Cluster topology management function
After the cluster topology becomes stable, you can use the topology management
commands on the cluster administrative device to save the topology of the current
cluster as the standard topology and back up the standard topology on the Flash
memory of the administrative device.
When errors occur to the cluster topology, you can replace the current topology with the
standard cluster topology and restore the administrative device using the backup
topology on the Flash memory, so that the devices in the cluster can resume normal
operation.
With the display cluster current-topology command, the switch can display the
topology of the current cluster in a tree structure. The output formats include: