Operation Manual – CLI
H3C S3100 Series Ethernet Switches Chapter 1 CLI Configuration
1-2
z Monitor level (level 1): Commands at this level are mainly used to maintain the
system and diagnose service faults, and they cannot be saved in configuration file.
Such commands include debugging and terminal.
z System level (level 2): Commands at this level are mainly used to configure
services. Commands concerning routing and network layers are at this level.
These commands can be used to provide network services directly.
z Manage level (level 3): Commands at this level are associated with the basic
operation modules and support modules of the system. These commands provide
support for services. Commands concerning file system, FTP/TFTP/XModem
downloading, user management, and level setting are at this level.
II. User privilege level
Users logged into the switch fall into four user privilege levels, which correspond to the
four command levels respectively. Users at a specific level can only use the commands
at the same level or lower levels.
By default, the Console user (a user who logs into the switch through the Console port)
is a level-3 user, and Telnet users are level-0 users.
You can use the user privilege level command to set the default user privilege level for
users logging in through a certain user interface. For details, refer to Login Operation.
 Note:
If a user logs in using AAA authentication, the user privilege level depends on the
configuration of the AAA scheme. For details, refer to AAA Operation.
1.2.2 Modifying the Command Level
I. Modifying the Command Level
Commands fall into four levels: visit (level 0), monitor (level 1), system (level 2), and
manage (level 3). By using the following command, the administrator can change the
level of a command in a specific view as required.
Table 1-1 Set the level of a command in a specific view
Operation Command Remarks
Enter system view
system-view
—
Configure the level of a
command in a specific view
command-privilege level level view
view command
Required
To Next Page
Loading...
Need help?
General