Operation Manual – QoS-QoS Profile
H3C S3100 Series Ethernet Switches Chapter 1 QoS Configuration
1-33
I. Configuration prerequisites
The burst function is required.
II. Configuration procedure
Table 1-33 Enable the burst function
Operation Command Description
Enter system view
system-view
—
Enable the burst
function
burst-mode enable
Required
By default, the burst function is
disabled.
III. Configuration example
Enable the burst function.
Configuration procedure:
<Sysname> system-view
[Sysname] burst-mode enable
1.4.11 Configuring Traffic Mirroring
Note:
Only H3C S3100-EI series switches support this configuration.
Refer to section
Traffic Mirroring for information about traffic mirroring.
I. Configuration prerequisites
z The ACL rules for traffic classification are defined. Refer to the ACL module of this
manual for information about defining ACL rules.
z The destination mirroring port is determined.
II. Configuration procedure
You can configure traffic mirroring on all the packets matching specific ACL rules, or on
packets that match specific ACL rules and are of a VLAN, of a port group, or pass a
port.
To Next Page
Loading...
