H3C S3100 8C SI User Manual

Operation Manual – Link Aggregation
H3C S3100 Series Ethernet Switches Chapter 1 Link Aggregation Configuration
1-11
Caution:
If you have saved the current configuration with the save command, after system
reboot, the configuration concerning manual and static aggregation groups and their
descriptions still exists, but that of dynamic aggregation groups and their descriptions
gets lost.
1.5 Displaying and Maintaining Link Aggregation
Configuration
After the above configuration, you can execute the display command in any view to
display the running status after the link aggregation configuration and verify your
configuration. Execute the reset command in user view to clear LACP statistics on
ports.
Table 1-5 Display and maintain link aggregation configuration
Operation Command Remarks
Display summary information of all
aggregation groups
display link-aggregation
summary
Display detailed information of a
specific aggregation group or all
aggregation groups
display link-aggregation
verbose [ agg-id ]
Display link aggregation details of a
specified port or port range
display link-aggregation
interface interface-type
interface-number [ to
interface-type
interface-number ]
Display local device ID
display lacp system-id
Available in
any view
Clear LACP statistics about a
specified port or port range
reset lacp statistics
[ interface interface-type
interface-number [ to
interface-type
interface-number ] ]
Available in
user view

H3C S3100 8C SI Specifications

General

Brand	H3C
Model	S3100 8C SI
Category	Switch
Language	English