H3C S3100 8C SI - Managing a Cluster through the Management Device

Operation Manual – Stack-Cluster
H3C S3100 Series Ethernet Switches Chapter 2 Cluste
r
2-17
III. Enabling NTDP globally and on a specific port
Follow these steps to enable NTDP globally and a specific port:
Operation Command Description
Enter system view
system-view
—
Enable NTDP globally
ntdp enable
Required
Enter Ethernet port view
interface interface-type
interface-number
—
Enable NTDP on the port
ntdp enable
Required
IV. Enabling the cluster function
Follow these steps to enable the cluster function:
Operation Command Description
Enter system view
system-view
—
Enable the cluster
function globally
cluster enable
Optional
By default, the cluster
function is enabled.
V. Accessing the shared FTP/TFTP server from a member device
Follow these steps to access the shared FTP/TFTP server from a member device:
Operation Command Description
Access the shared FTP server of
the cluster
ftp cluster
Optional
Download a file from the shared
TFTP server of the cluster
tftp cluster get source-file
[ destination-file ]
Optional
Upload a file to the shared TFTP
server of the cluster
tftp cluster put source-file
[ destination-file ]
Optional
2.2.3 Managing a Cluster through the Management Device
You can manage the member devices through the management device, for example,
adding/removing a cluster member, rebooting a member device, logging into a member
device, and so on.
Follow these steps to manage a cluster through management device: