H3C S3100 8C SI - Troubleshooting Ethernet Port Configuration

Operation Manual – Port Basic Configuration
H3C S3100 Series Ethernet Switches Chapter 1 Port Basic Configuration
1-12
III. Configuration procedure
 Note:
z Only the configuration for Switch A is listed below. The configuration for Switch B is
similar to that of Switch A.
z This example supposes that VLAN 2, VLAN 6 through VLAN 50 and VLAN 100 have
been created.
# Enter Ethernet 1/0/1 port view.
<Sysname> system-view
[Sysname] interface ethernet1/0/1
# Set Ethernet 1/0/1 as a trunk port.
[Sysname-Ethernet1/0/1] port link-type trunk
# Allow packets of VLAN 2, VLAN 6 through VLAN 50 and VLAN 100 to pass
Ethernet1/0/1.
[Sysname-Ethernet1/0/1] port trunk permit vlan 2 6 to 50 100
# Configure the default VLAN ID of Ethernet1/0/1 to 100.
[Sysname-Ethernet1/0/1] port trunk pvid vlan 100
1.3 Troubleshooting Ethernet Port Configuration
Symptom: Fail to configure the default VLAN ID of an Ethernet port.
Solution: Take the following steps.
z Use the display interface or display port command to check if the port is a trunk
port or a hybrid port.
z If the port is not a trunk or hybrid port, configure it to be a trunk or hybrid port.
z Configure the default VLAN ID of the port.