H3C S3100 8C SI - Setting to Output System Information to the Trap Buffer; Setting to Output System Information to the Log Buffer

Operation Manual – Information Center
H3C S3100 Series Ethernet Switches Chapter 1 Information Center
1-15
1.2.7 Setting to Output System Information to the Trap Buffer
Table 1-13 Set to output system information to the trap buffer
Operation Command Description
Enter system view
system-view
—
Enable the information
center
info-center enable
Optional
Enabled by default.
Enable system
information output to the
trap buffer
info-center trapbuffer
[channel
{ channel-number |
channel-name } | size
buffersize]*
Optional
By default, the switch
uses information channel
3 to output trap
information to the trap
buffer, which can holds up
to 256 items by default.
Configure the output rules
of system information
info-center source
{ modu-name | default }
channel
{ channel-number |
channel-name } [ { log |
trap | debug } { level
severity | state state } ]*
Optional
Refer to
Table 1-8 for the
default output rules of
system information.
Set the format of time
stamp in the output
information
info-center timestamp
{ log | trap | debugging }
{ boot | date | none }
Optional
By default, the time stamp
format of the output trap
information is date.
1.2.8 Setting to Output System Information to the Log Buffer
Table 1-14 Set to output system information to the log buffer
Operation Command Description
Enter system view
system-view
—
Enable the information
center
info-center enable
Optional
Enabled by default.
Enable information output
to the log buffer
info-center logbuffer
[ channel
{ channel-number |
channel-name } | size
buffersize ]*
Optional
By default, the switch
uses information channel
4 to output log information
to the log buffer, which
can holds up to 512 items
by default.