Operation Manual – IPv6 Management
H3C S3100 Series Ethernet Switches Chapter 2 IPv6 Application Configuration
2-1
Chapter 2 IPv6 Application Configuration
2.1 Introduction to IPv6 Application
IPv6 are supporting more and more applications. Most of IPv6 applications are the
same as those of IPv4. The applications supported on H3C S3100 Series Ethernet
Switches are:
z Ping
z Traceroute
z TFTP
z Telnet
2.2 IPv6 Application Configuration
2.2.1 IPv6 Ping
The ping ipv6 command is commonly used for testing the reachability of a host. This
command sends an ICMPv6 message to the destination host and records the time for
the response message to be received. For details about the ping command, refer to
System Maintenance and Debugging.
After you execute the ping ipv6 command, you can press Ctrl+C to terminate the ping
operation.
Table 2-1 Ping IPv6
To do… Use the command… Remarks
Ping IPv6
ping ipv6 [ -a source-ipv6 | -c count |
-m interval | -s packet-size | -t timeout ]*
remote-system [ -i interface-type
interface-number ]
Required
Available in any view
Caution:
When you use the ping ipv6 command to verify the reachability of the destination, you
must specify the “–i” keyword if the destination address is a link-local address.
To Next Page
Loading...
Need help?
General